Ink cartridges are not used indefinitely. The operation is also a few times, the number of times is too much, the sponge of the ink cartridge can not contain ink, and there is ink leakage. The chip of the printer cartridge has the recorded ink usage. As long as no ink is detected, the printer does not work and requires a new ink cartridge. Although you have added ink, the chip record has not changed, and it is still considered as no ink. The only way to resolve this issue is to clear the cartridge chip. So what are the methods of hp ink cartridge refilling?
First, the filling method of the black ink cartridge: (28, 57, 817)
1. Remove the label on the top of the cartridge and see five small holes under the label;
2. Insert the needle into one of the small holes to inject the ink, and inject a proper amount of ink;
3. Wipe the small holes around and stick the labels.
Second, the color hp ink cartridge filling method: (28, 57, 817)
1. Remove the label on the top of the cartridge and see five small holes under the label;
2. Distinguish the color, one hole is red, two holes are blue, and two holes are yellow;
3. Under the nozzle, pad the paper with a good point, not to lose the paper dust, so as to prevent the ink from coloring from the nozzle. If it is a slight cross color, you can solve it by playing several color blocks. law).
4. Put the needle into the small hole to inject the ink, and inject a proper amount of ink.
5. Wipe the small holes around and stick the labels.
Third, 816, 817 cartridge scale refresh
1. The ink cartridge contacts face toward you and the ink outlet faces down.
2. For the first time, stick the first contact on the upper end of the second column on the left side with the strip, and start to detect the ink volume of the ink cartridge. The host gives an error and does not care. Shut down.
3. Boot, the first strip does not go, stick the three contacts from the left to the right of the fifth column at the upper end 1 and 2 and the sixth column at the upper end, and then measure the amount of ink, the host again gives an error and ends. Shut down.
4. Boot, remove the ink cartridge, remove the rubber strip, shut down after the safety, the amount of ink measured at the start: the ink cartridge is full! Finish!
The above is the introduction of the hp cartridge ink, I hope to help everyone.
Nantong Zhuoluo International Trading Co., Ltd , https://www.zlhomedecor.com