What if the label is stuck after the die-cut

In self-adhesive label printing, the label is often peeled off by the paper edge scraps during die-cutting and aligning processing. In particular, some small-area labels cause the labels shown in FIG. 1 to be missing. What should I do if the label is stuck after the die cut? 1. From the design of the label, the area of ​​the label should be appropriately increased, the shape of the label should not be too complicated, and a reasonable arrangement of labels should be used; Properly reduce the temperature of the adhesive material storage room and the printing shop, prevent the viscosity of the adhesive material on the surface of the adhesive material from declining, or use the adhesive material with a larger viscosity to print; 3. Replacing the die-cutting plate by replacing the die-cutting blade with a long use time and blunt blade or bonding the sponge piece between the die-cut plate and the blade; 4. Through the method of die-cutting the bottom plate, the pressure of the die plate is adjusted so that the pressure of the die plate is even and the depth of the die-cut creasing is consistent; Accelerate the speed of die-cutting.