The best choice for die cutting

(Getting The Best Selection for Diecutting Needs) The cost per thousand sheets of paper cutting (CPM) is an economic indicator that can help the carton shop select the best tool for a specific job. Understanding the quantitative characteristics of CPM indicators, combined with other important indicators, can work with higher efficiency. 1. Different die-cutting methods are used for installation and readiness, and the time for installation and readiness changes greatly. If sorting by time, the entity punching is the shortest, followed by plate punching, followed by physical pressure cutting, and finally paper pressing. In general, the time required for the installation of the punching method is relatively short, the technology is not complicated, and the adjustment of the machine is also very small, which is suitable for use by general personnel. Press cutting is more complicated and requires operators with rich professional experience and high work proficiency. 2. Work Speed ​​In general, when the rotary table is installed and adjusted, the working speed is extremely fast. However, novices are generally willing to use the slower roll-type die-cutting, and after this die-cutting method, a peeling-off process is performed, which is commonly known as a peeling machine. Sometimes the machine has to make some small gaps to help the machine send the remaining paper stock together with the die-cut forming paper stock to the next peeling process, but sometimes these small gaps will affect the working speed of the entire machine, so Currently, die-cutting machine manufacturers generally do not set these small openings on their die-cutting machines. This process is completely passed on to the user. Therefore, the difference in user's operating proficiency will cause a great deal of damage to the user's die-cutting/stripping speed. Big difference. Of course, there is also a less economical way to pre-process all the cardboard into a rough outline, and then die-cut, so that the leftovers can be arranged in a unified manner, and this small gap is not necessary. However, this kind of working method has low utilization rate of cardboard and is more suitable for short-run printing. 3. Skilled workers It is clear that the technical condition of workers is also an important factor that influences the selection of suitable die-cutting tools. At present, most newcomers who use rotary table die-cutting machines begin with the physical die-cutting equipment. They are becoming more and more complicated and have come to use such machines step by step. The human factor can not be ignored because the loss of the downtime caused by the learning process is far greater than any die-cutting method or method improvement. Starting from the simplest method, operators can continuously increase their confidence and experience, and the company’s products can also exhibit the best stability. Accordingly, the user’s trust and support will continue to increase. 4. Supporting equipment Each kind of machine needs supporting equipment to complete the corresponding work. The specific equipment will be different depending on the mode or method of the selected die cutting operation. The following lists the commonly used equipment selected for the die cutter. * Entity die-cutting die-cutting machine: peeling pin, peeling comb and die-cutting gear device, etc.; * Reel plate die-cutting die-cutting machine: drum, paper stripping machine roller, peeling pin, stripping comb And die-cutting gear device, etc. * Physical die-cutting die-cutting machine: peeling pin, peeling comb, bearing, bearing sleeve and die-cutting gear device, etc.; * Reel plate type die-cutting die-cutting machine: drum, paper stripping Paper machine roll, stripping paper, peeling comb, bearing, bearing sleeve and die-cutting gear. Note: The above-mentioned drum is a general-purpose device, and it is not necessary to provide special configuration for each die-cutting machine. However, bearings and bearing sleeves must be based on different die-cutting equipment to select different products and belong to special supporting devices. 5. Services and Training Provided by Suppliers Although each supplier usually only sells a certain type of die-cutting machine, it is indispensable for the evaluation of the supporting services and training provided by them. Sometimes, a machine is the best choice from the technical performance, but the lack of related services and training will make the processing plant not another choice. When dealing with new suppliers, it is important to understand their past in order to ensure that they do provide the products with the necessary services in the future.