The plate processor must be installed on a flat, clean indoor floor. For ease of operation and maintenance, the space must be no less than 750mm wide left and right on the machine. There must be sufficient entry and exit space before and after the machine. This article will introduce you to the Kodak processor.
Many users who use the T-series processor may encounter a failure when the button is turned on and any button on the touch screen is unresponsive. This failure will cause the processor to not enter the standby state normally. This fault is caused by the potential drift of the scanner's touch screen. If this happens, please follow the steps below to recalibrate the processor touch screen to troubleshoot.
Turn on the main power of the processor. If the processor has been turned on, please turn off the main power of the processor and turn it on again. After the shutdown, please wait 20 seconds - 20 seconds before turning on the main power of the processor.
After the screen correction is completed, the prompt message PressthegreenStartbutton will appear again on the screen. Now press the green start button next to the screen, the device starts normally, and the fault that the touch screen does not respond can be eliminated.
Use the special cleaning agent for the platen machine, just dilute the concentrate with water, heat it to the developing machine tank and heat it to 30 °C, and start the cycle for 30 minutes to clean the dirt in the tank. Or dilute the concentrate with water, dip with a brush, brush the tank, rubber roller and brush. Please refer to the product's instruction manual for the specific dilution ratio.
Article source address: http://
Box Products,Paper Mache Boxes,Paper Box Packaging,Paper Take Out Boxes
Ningbo DSS Intelligent Technology Co., Ltd , https://www.dssking.com